Removing parts - Printable Version

Removing parts - Printable Version

+- JapCarForum (https://www.japcarforum.com)
+-- Forum: Cars, Cars, Cars! (https://www.japcarforum.com/forumdisplay.php?fid=11)
+--- Forum: General Car Maintenance (https://www.japcarforum.com/forumdisplay.php?fid=150)
+--- Thread: Removing parts (/showthread.php?tid=12218)

Pages: 1 2

Removing parts - Colin G - 15-02-2021

Ok guys, need some help, Please.

I'm currently dismantling my 300zx. It has a racelogic traction control system (with launch control) fitted. Could somebody please tell me what is involved in removing this as I have absolutely no idea.

Removing parts - Sparkystav - 16-02-2021

It should have a main silver brain unit. You need to find that.

That should have a loom going to the abs ecu. That can just be cut as they're only spliced in.
A loom to the main ecu for the injectors. This will need to be followed to the ecu as they intercept the injector wires so you'll need to join therm back together to get the car running again.
Then a loom to the controller.

If there's a second plug in the main unit then there's a final loom with the diagnostic plug and led on it as well.

Removing parts - Colin G - 16-02-2021

Thats brilliant, will have a look next time I'm out at the car. Not too worried about joining wires back together, car is being stripped due to a dead engine.

Removing parts - Rabster - 16-02-2021

Dibs on any parts lol

Removing parts - Colin G - 16-02-2021

I'm sure that can be arranged Wink

Removing parts - Rabster - 16-02-2021

:offtopic:

how does 11am sound ?

Removing parts - Colin G - 16-02-2021

Yeah that's fine mate. Could you drop us a pm with the house name, so i know which one it is (i know roughly, but better to be safe) lol

Removing parts - Rabster - 16-02-2021

The one with the big black Truck in it lol

Removing parts - Colin G - 17-02-2021

Been trying to do a bit to the 300 this afternoon, got most of the racelogic out now, and also started on the sigma alarm system though I think thats going to be more than I can cope with after tracing some of the wires.

Anyway, back to the racelogic. I traced the controller wire back to the main brain of it
[Image: racelogic001_zps43096b14.jpg]

I then started to trace each of the wires coming out of that, and got to this
[Image: racelogic002_zpsc11f6482.jpg]

Now the wire hanging off the edge of the car is still connected but wanted to make sure I remove from the correct place. Anyway in the pic below the wire coming up from under my hand is the one I'm concerned about as it seems to be spliced into the wires going into the blue plug, but also seems to be spliced into the four thick grey wires coming from above.
[Image: racelogic003_zps55844487.jpg]

Is that where I need to cut (blue/red/yellow/green wires) to finish removing it or is there still more to find??

Removing parts - Sparkystav - 17-02-2021

Yeah cut there, they are the wires to the abs sensors.