JapCarForum
My new toys - Printable Version

+- JapCarForum (https://www.japcarforum.com)
+-- Forum: Cars, Cars, Cars! (https://www.japcarforum.com/forumdisplay.php?fid=11)
+--- Forum: Project Cars (https://www.japcarforum.com/forumdisplay.php?fid=156)
+--- Thread: My new toys (/showthread.php?tid=725)



My new toys - dimis - 27-05-2019

The Jun flywheel finally arrived today home. I had to pay custom charges unfortunately, but at the end of the day the total cost was much cheaper from a known UK shop.


My new toys - dimis - 28-05-2019

Gord Now for the mass fitting of all the parts mate Big Grin

Yes mate :thumbup::thumbup::thumbup:


My new toys - dimis - 29-06-2019

Well I am back home again and modding has started after a pause of 5 months. Today I install the clear crystal fog lights on the boot.

[Image: di-Q7CJ.jpg]

[Image: di-2IW8.jpg]

I believe they look much better than the oem red lights. Next mod in the list is to fit on Tuesday the Supra brakes.


My new toys - Moley - 29-06-2019

I agree with the fog lights , and Supra brakes will be an ace mod for your car mate !


My new toys - Stoney - 30-06-2019

I've got some clear fogs to fit, maybe today even. Wish I had Supra brakes too!

Sent from my GT-I9100 using Tapatalk


My new toys - dimis - 30-06-2019

Gord Yes i like the clear fogs on your car mate, they go with the rear lights Big GriniscoStu:

Thanks mate!!!


My new toys - dimis - 30-06-2019

Stoney I've got some clear fogs to fit, maybe today even. Wish I had Supra brakes too!

Sent from my GT-I9100 using Tapatalk

You should fit them mate, easy mod.


My new toys - dimis - 01-07-2019

A photo I took today:

[Image: di-YUU4.jpg]


My new toys - Stoney - 01-07-2019

dimis You should fit them mate, easy mod.

I did fit them! Though not as easy as I had hoped, they needed some gentle persuasion (hacking with kitchen knives) to get the bulb holders to fit. And I am not 100% happy with the light output from the red bulbs, so will order some LED ones. (I have these light wired to run as brake lights.)


My new toys - dimis - 01-07-2019

Stoney I did fit them! Though not as easy as I had hoped, they needed some gentle persuasion (hacking with kitchen knives) to get the bulb holders to fit. And I am not 100% happy with the light output from the red bulbs, so will order some LED ones. (I have these light wired to run as brake lights.)

I had the same problem mate, had to use a knive to get the bulb holders to fit in the lights.