JapCarForum
Back to Jap! - Printable Version

+- JapCarForum (https://www.japcarforum.com)
+-- Forum: General Discussions (https://www.japcarforum.com/forumdisplay.php?fid=3)
+--- Forum: The JCF Lounge (https://www.japcarforum.com/forumdisplay.php?fid=17)
+---- Forum: Car Related Chat (https://www.japcarforum.com/forumdisplay.php?fid=147)
+---- Thread: Back to Jap! (/showthread.php?tid=13508)

Pages: 1 2


Back to Jap! - Mikey - 31-03-2022

Right bought another intake pipe which i used a mikalor clamp to secure but has totaly smashed it to bits so the old one is back on untill i can get another or im going to make one out of aluminium we will see haw the search goes.

[Image: IMAG0060.jpg]

on the up side my decat has turned up yippee

[Image: IMAG0067.jpg]


Back to Jap! - Mikey - 12-01-2023

Car has been away over winter period and with it being away i couldnt just leave it there and do nothing to it,

plus ive been doing a bit of fishing with my lad

[Image: bYH9IrSmCcG4tDGYFPTKpVonM_Magzk7IMrcvmoc...-h227-p-no]

[Image: IMG-20141122-WA0025.jpg]

Back to the car

Rear subframe is off and down the powdercoaters

Bushes still have not turned up should be here today but not holding up on that, ive gone for the Strongflex yellow kit, some of the geo bolts were sized & what fun it is cutting them out

oils have turned up from OPIE OILS in record time, great service

[Image: IMAG0883.jpg]

Caliper refurb kit for the rears have turned up thanks BIGG RED

just need to order Disks and pads for the back - pads for the front, and some new geo bolts.

So the car should be begining to be reassembled some time next week.

A pic of the subframe while its off

[Image: received_607325142744158.jpeg]


Back to Jap! - FOSSIL FUELS - 13-01-2023

Nice project... Won't be too long until it's back on the road then Wink


Back to Jap! - Mikey - 13-01-2023

Hope fully not mate im itching to get back in it.

Bushes turned up today finally. I said i orderd the yellow kit in previous post i was wrong i orderd the red kit which is the one i wanted :Chair:

They are really good quality, Knurling to the inside of the bush to hold grease better, chamfered edges and the inside of the metal insert has been rough grooved to hold the grease as well.

[Image: IMAG0900.jpg]

[Image: IMAG0898.jpg]

[Image: IMAG0899.jpg]


Back to Jap! - Mikey - 13-01-2023

Could Mods move this into the Honda or project section as its kind of a build thread and delete this post when its done.


Back to Jap! - FOSSIL FUELS - 13-01-2023

I would advise to start a new thread as your early pics have dropped out.