+- JapCarForum (https://www.japcarforum.com)
+-- Forum: Cars, Cars, Cars! (https://www.japcarforum.com/forumdisplay.php?fid=11)
+--- Forum: Project Cars (https://www.japcarforum.com/forumdisplay.php?fid=156)
+--- Thread: Lexus is200 se (/showthread.php?tid=13061)
Lexus is200 se - is200turbo - 18-03-2024
Is it silicone bends u need as I will have some 3" stainless bends left over
Sent from my iPhone using Tapatalk
Lexus is200 se - Wayne - 18-03-2024
Nah 2 inch. The induction side is done, I'm needing from the intercooler to the TB side
Lexus is200 se - is200turbo - 18-03-2024
I've got 2.5" on mine so can't help I'm afraid
Sent from my iPhone using Tapatalk
Lexus is200 se - Wayne - 18-03-2024
I tried 2.5, it seemed a bit too tight.
Lexus is200 se - is200turbo - 18-03-2024
Where was it tight mate
Sent from my iPhone using Tapatalk
Lexus is200 se - Wayne - 18-03-2024
Passenger side going down to the intercooler. It looked too close to that pulley for my liking. You running 2.5" all round?
Lexus is200 se - is200turbo - 18-03-2024
I'm goin to try to yeah
Sent from my iPhone using Tapatalk
Lexus is200 se - Wayne - 18-03-2024
I was struggling to get 2.5" past that (green circle) pulley, it was way too close for my liking. Anybody know what the red arrow is pointing to? It looks like a relay of some kind.
![[Image: 2con1wy.png]](http://i67.tinypic.com/2con1wy.png)
Lexus is200 se - Jimbob-T-Lex - 19-03-2024
Airbag sensor to set them off
Lexus is200 se - is200turbo - 25-03-2024
My clutch is goin to need changing very soon can any 1 recommend a good 1 that can cope with the extra power the turbo will produce
Sent from my iPhone using Tapatalk