+- JapCarForum (https://www.japcarforum.com)
+-- Forum: General Discussions (https://www.japcarforum.com/forumdisplay.php?fid=3)
+--- Forum: The JCF Lounge (https://www.japcarforum.com/forumdisplay.php?fid=17)
+--- Thread: Custom Dome Badges (/showthread.php?tid=6001)
Custom Dome Badges - Moley - 26-09-2018
Jay this is what I'm looking for ........
![[Image: 008-1.jpg]](http://i300.photobucket.com/albums/nn9/moleypics/008-1.jpg)
![[Image: 007-1.jpg]](http://i300.photobucket.com/albums/nn9/moleypics/007-1.jpg)
![[Image: 006-1.jpg]](http://i300.photobucket.com/albums/nn9/moleypics/006-1.jpg)
![[Image: 005-1.jpg]](http://i300.photobucket.com/albums/nn9/moleypics/005-1.jpg)
![[Image: 004-1.jpg]](http://i300.photobucket.com/albums/nn9/moleypics/004-1.jpg)
for these wheels....
![[Image: 037-1.jpg]](http://i300.photobucket.com/albums/nn9/moleypics/037-1.jpg)
![[Image: 038-1.jpg]](http://i300.photobucket.com/albums/nn9/moleypics/038-1.jpg)
the outside size is 70mm
the clip size is metal ring 60 mm and with the plastic clip is 64 or 65 mm
Custom Dome Badges - jay_russell - 26-09-2018
will see what i can do. might be able to get you something like that. just one question. do they clip in place or are they held from behind.
Custom Dome Badges - Moley - 26-09-2018
They clip in place mate .
Custom Dome Badges - jay_russell - 26-09-2018
will look at work and see what i can come up with. are you planning to put center details on them
Custom Dome Badges - Moley - 26-09-2018
yes Jay, I got Jason to make me up a set of TTE one that he made for the gear knobs.
And they fit nice on my caps
Custom Dome Badges - jay_russell - 26-09-2018
what size are they then mate.
Custom Dome Badges - Moley - 26-09-2018
25mm I've got one fitted already to a centre cap from my 5'th wheel cap which is not corroded
Custom Dome Badges - Bandit - 26-09-2018
Are they metal or plastic mate?
Custom Dome Badges - Moley - 26-09-2018
Metal , think aluminium but have not tried the magnet test
Custom Dome Badges - Bandit - 26-09-2018
Just had another look at the pic's mate and they look like alloy? Have you got any fine wire wool? If you have give one a light rub down using autosol and the wire wool to see if it removes the lacquer? If it does and you start to see a shine to it, you can rub the lot down, give them a good clean with white spirit and then give a light coat of spray lacquer, if there too bright give them another coat of lacquer as it will tone them down a little with every coat you give them?
If i polish them they will come up pretty shiny, but can give them a go if you want me to mate? you might just have to tone them down a bit with lacquer when you get them back? i'll give them a couple of coats of lacquer anyway so it gives them a bit of protection :thumbup1: