+- JapCarForum (https://www.japcarforum.com)
+-- Forum: Cars, Cars, Cars! (https://www.japcarforum.com/forumdisplay.php?fid=11)
+--- Forum: Project Cars (https://www.japcarforum.com/forumdisplay.php?fid=156)
+--- Thread: Stix's IS200 (/showthread.php?tid=10506)
Stix's IS200 - S - 16-05-2020
Started extending my Greddy E-Manage loom while I research how to fit it!
![[Image: IMAG0342.jpg]](http://i77.photobucket.com/albums/j60/dopple-ganger/Greddy%20E-Manage/IMAG0342.jpg)
Only 40 more wires to go!
Stix's IS200 - dimis - 16-05-2020
good luck mate
Stix's IS200 - Sparkystav - 16-05-2020
Lol it's a fun project isn't it mate!
Stix's IS200 - S - 16-05-2020
Thanks Dimis,
It's not as bad as I thought it was going to be but I could do with one of those stands that holds the two wires in place that or an extra arm! Lol
Tbh I'm struggling/worrying about fitting it and the "jumper" settings I should use (the ECU has came from a drag skyline so I'm assuming the jumper settings will be wrong)
Stix's IS200 - S - 19-05-2020
Halfway:
![[Image: IMAG0344.jpg]](http://i77.photobucket.com/albums/j60/dopple-ganger/Greddy%20E-Manage/IMAG0344.jpg)
The 3 sub looms extended ready to be wrapped:
![[Image: IMAG0345.jpg]](http://i77.photobucket.com/albums/j60/dopple-ganger/Greddy%20E-Manage/IMAG0345.jpg)
The 3 sub looms wrapped up together:
![[Image: IMAG0346.jpg]](http://i77.photobucket.com/albums/j60/dopple-ganger/Greddy%20E-Manage/IMAG0346.jpg)
Each wire labelled to aid fitting:
![[Image: IMAG0349.jpg]](http://i77.photobucket.com/albums/j60/dopple-ganger/Greddy%20E-Manage/IMAG0349.jpg)
Stix's IS200 - Sparkystav - 19-05-2020
Good work mate. Bet that took ages lol. Now imagine doing that on a whole loom in the engine bay lol
Stix's IS200 - S - 19-05-2020
it did take ages mate! HA no thanks! This loom was bad enough! lol
It didnt help that the solder i bought was utterly rubbish!! luckily my lasses dad has some plumbing solder and flux paste and its the best solder ive ever used!
Im going to open the actual ECU up tonight or tomorrow and check the jumper settings and then mabee run the loom through the fire wall.
Stix's IS200 - S - 19-05-2020
Jumpers Checked
Stix's IS200 - Sparkystav - 19-05-2020
Everything ok with the jumpers?
Stix's IS200 - S - 19-05-2020
yeah seemed to be most of them controled whether or not your adding&removing fuel or if you only want to add so I thought I'd keep my options open lol
I'm not sure how, if at all, I can control VVTi so ill have to try and work that one out.
I'm going to run the cable tomorrow