JapCarForum
It's about time OJC had one of these.... - Printable Version

+- JapCarForum (https://www.japcarforum.com)
+-- Forum: Cars, Cars, Cars! (https://www.japcarforum.com/forumdisplay.php?fid=11)
+--- Forum: Project Cars (https://www.japcarforum.com/forumdisplay.php?fid=156)
+--- Thread: It's about time OJC had one of these.... (/showthread.php?tid=12991)

Pages: 1 2 3 4 5 6 7 8 9 10 11 12


It's about time OJC had one of these.... - Lexuspat - 24-06-2022

Thats never a good sign mate how manys that uve done now

Sent from my GT-I9505 using Tapatalk


It's about time OJC had one of these.... - posty - 24-06-2022

That's the second one since I've had it. Last was October last year.


Sent from my iPad using Tapatalk


It's about time OJC had one of these.... - Lexuspat - 24-06-2022

Thats not hugely bad then if it was doing it fast id be major concered.

Get it looked at mate im sure ur sort it

Sent from my GT-I9505 using Tapatalk


It's about time OJC had one of these.... - Sparkystav - 24-06-2022

Hmm very odd!

Could be like my problem and lifting the head under boost, and pressurising the coolant?


It's about time OJC had one of these.... - posty - 24-06-2022

Im really not sure where to start tbh. The wheels span in the wet in 2nd, I bounced off the rev limiter a few times and it blew?


Sent from my iPad using Tapatalk


It's about time OJC had one of these.... - Sparkystav - 24-06-2022

So when your on boost basically, engine gases are getting into the coolant and over pressurising the system, the weak point is obviously the rad.

Unless you've got a blockage and the water is just pressurising as it goes round the engine cause it's no where to go. Have you had any over heating issues?


It's about time OJC had one of these.... - posty - 25-06-2022

Nope no overheating issues at all! I'm sending the rad back to driftworks under warranty which is a bonus! Fingers crossed they honour it!


Sent from my iPad using Tapatalk


It's about time OJC had one of these.... - Sparkystav - 25-06-2022

Hope its just a manufacturing fault then mate


It's about time OJC had one of these.... - posty - 25-06-2022

Fingers crossed, but I'm going to get a compression test done to check the head!


Sent from my iPad using Tapatalk


It's about time OJC had one of these.... - Sparkystav - 25-06-2022

It might be only when the boost is on though mate, lifting the head up.
A change to Arp bolts could help.