+- JapCarForum (https://www.japcarforum.com)
+-- Forum: Cars, Cars, Cars! (https://www.japcarforum.com/forumdisplay.php?fid=11)
+--- Forum: Project Cars (https://www.japcarforum.com/forumdisplay.php?fid=156)
+--- Thread: Posty's IS200 SE (/showthread.php?tid=5156)
Posty's IS200 SE - posty - 13-03-2019
Well today I fitted the boost gauge I bought. It was a pig of a job, my hands just dont go into gaps that small. but i eventually won!
In a temporary position untill i sort out some other gauges and make a pod for them!
![[Image: picture225a.jpg]](http://img718.imageshack.us/i/picture225a.jpg/)
Im not too clued up on boost etc etc. but i get to a fraction under 0.3 when accelerating hard at about 5k revs.
Does this sound good or bad?
Posty's IS200 SE - Moley - 13-03-2019
That sounds about right Posty
Posty's IS200 SE - dandydons - 13-03-2019
Congrats guys - am pretty sure the hole in the pipework was where the air sensor was !
Posty's IS200 SE - Sparkystav - 13-03-2019
That makes sense but i always fitted it before the changer when the airs not pressurized, it fitting it in the pressurised pipework you should make sure youve got a good seal
Posty's IS200 SE - posty - 13-03-2019
the air sensor went into the bottom of the induction kit! there was a hole there for it.
Posty's IS200 SE - Bandit - 13-03-2019
Think that hole might of been the one i had in it? i had an extension pipe there which was sealed into the hose for the air sensor :whistling:
Posty's IS200 SE - dandydons - 13-03-2019
posty the air sensor went into the bottom of the induction kit! there was a hole there for it.
thats the one mate.
Posty's IS200 SE - Jambo - 13-03-2019
dandydons thats the one mate.
Yerh, the hole/gash in the pipe was from Bandit, as it was from the air filter area, so the O2 sensor could get into it....
Posty's IS200 SE - ormi - 13-03-2019
Bandit Think that hole might of been the one i had in it? i had an extension pipe there which was sealed into the hose for the air sensor :whistling:
it was a straight cut mate you couldnt put a extension piece in their it would never seal???
Posty's IS200 SE - ormi - 14-03-2019
Tape won't seal a pressured system..
The hole for the sensor was approx two inches from the cone filter on the bottom...