+- JapCarForum (https://www.japcarforum.com)
+-- Forum: Cars, Cars, Cars! (https://www.japcarforum.com/forumdisplay.php?fid=11)
+--- Forum: Project Cars (https://www.japcarforum.com/forumdisplay.php?fid=156)
+--- Thread: Little write up on the evolution of my car (/showthread.php?tid=645)
Pages:
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
Little write up on the evolution of my car - Rabster - 31-03-2020
Could it be a resistance issue from the re wire wrong gauge cable maybe ?
Little write up on the evolution of my car - Rabster - 31-03-2020
Ooh one thing that might do it interference on the ecu lines I moved my aem fix to inside the car from the bay and the car worked fine but then stopped playing ball had to take it back out again and me it back to the engine bay that cured the problem
Just a thought
Little write up on the evolution of my car - speedfreek - 31-03-2020
Mapping issue perhaps?
I had similar issues on my old standalone and tweaks to the map helped massively.
Little write up on the evolution of my car - Sparkystav - 31-03-2020
Hmm it's n idea, I did use most of the standard loom to avoid that. And the resistance from the injectors/igniters back to the ecu is less than 1ohm in each case.
Little write up on the evolution of my car - Sparkystav - 31-03-2020
Just seems odd it was running fine then stopped, hadnt moved anything in the meantime.
Little write up on the evolution of my car - Sparkystav - 31-03-2020
speedfreek Mapping issue perhaps?
I had similar issues on my old standalone and tweaks to the map helped massively.
Hadnt change the map at all by then.
Little write up on the evolution of my car - mattlaw - 31-03-2020
Are you running a map or maf sensor?
Little write up on the evolution of my car - Rabster - 31-03-2020
Sparkystav Just seems odd it was running fine then stopped, hadnt moved anything in the meantime.
Couldn't a cable have moved to cause the problems and is now hanging against the loom causing a issue
Little write up on the evolution of my car - Sparkystav - 31-03-2020
mattlaw Are you running a map or maf sensor?
Map sensor built into the link ecu
Little write up on the evolution of my car - Sparkystav - 31-03-2020
Rabster Couldn't a cable have moved to cause the problems and is now hanging against the loom causing a issue
Hmm maybe, annoyingly the loom is well tucked away but I'll have a look, it's a good idea.