Help find me the bits to complete the Stagea GTR conversion - Printable Version +- JapCarForum (https://www.japcarforum.com) +-- Forum: Cars, Cars, Cars! (https://www.japcarforum.com/forumdisplay.php?fid=11) +--- Forum: General Car Maintenance (https://www.japcarforum.com/forumdisplay.php?fid=150) +--- Thread: Help find me the bits to complete the Stagea GTR conversion (/showthread.php?tid=9783)

Help find me the bits to complete the Stagea GTR conversion - Rabster - 02-01-2020 OK so after a drive of just under 500 miles at the weekend i have sourced 95% of the Masa Bodykit for my car so the finished article will look more or less like this beauty However i dont have the metal parts shown in the picture below and as such i would like to track them down I have been told they are not 100% necessary but does make fitting the kit a lot easier, newera are unable to help not sure the reason why but suspect its due to it only being a small order etc so does anyone else on here have any fingers in any pies with importers that can help source the last few bits fr this kit........ Help find me the bits to complete the Stagea GTR conversion - Dark Samurai - 02-01-2020 So you need the two wings and bonnet, and then like crash bars etc? Help find me the bits to complete the Stagea GTR conversion - Rabster - 02-01-2020 no no no I have the following for the conversion already Wings Bonnet Bumper Headlights Indicators Side Skirts Rear Lip I dont have any of the metal brackets that will hold it all together, things like Bonnet hinges Headlight Brackets Crash Bar Bonnet Catch etc etc Help find me the bits to complete the Stagea GTR conversion - jomo - 02-01-2020 Can some of those be gotten off a scraped R34 Skyline? There's a bloke around the corner from me who's just made his shorter at the back!!! Help find me the bits to complete the Stagea GTR conversion - Rabster - 02-01-2020 Ooh there is a possibility of getting some off the bits i have been told you can make it all fit using skyline parts just with a little bit of work so it could be i find a scrapped skyline and cut the front off and walk away lol Help find me the bits to complete the Stagea GTR conversion - FirebirdPhil - 02-01-2020 Problem with that is most crashed ones have front impacts?? You never know. What was the scrappy that Wayne worked in - they dealt with Jap import scrapping. Help find me the bits to complete the Stagea GTR conversion - Rabster - 02-01-2020 i have a contact from a skyline breakers so gonna give him a nudge, see if he can help ideally i wanted the genuine stuff so i know its a bolt on and bolt off system so to speak thus keeping the the time the car is off the road at a minimum Help find me the bits to complete the Stagea GTR conversion - Chri5 - 02-01-2020 i take it you dont need my assistance in getting these bits. i am up there this weekend. could of saved you a trip lol