IS200 Illuminated Sill Plate Fitting kits ??
IS200 Illuminated Sill Plate Fitting kits ??
![[Image: fairingbolllof.jpg]](http://i214.photobucket.com/albums/cc320/tempra5/fairingbolllof.jpg)
Rabs these would work CLICK ME?
I have some 10mm ones here but you'll need 8mm by the look of it to fit in the holes, there made of rubber with a metal thread inside, and when you add the bolt they expand in the hole making it watertight!
I've just been and tried the ones i have here but are a little too big being as the hole is about 9mm so 8mm would work a treat if you can get them? :thumbup1:
This is one i have here, just trimmed it down a bit to see if it'll fit but still a bit tight but it could be done as i only took a bit off the rubber casing? they sit pretty flush with the body work when there pushed all the way in!!
![[Image: fairingbolllof.jpg]](http://i214.photobucket.com/albums/cc320/tempra5/fairingbolllof.jpg)
:thumbup1:

![[Image: 395572195.jpg]](http://pic100.picturetrail.com/VOL744/3949855/20285147/395572195.jpg)
I need a set of these too if you can get hold of them 
The part number of the sill plates is PZ439-C0180-00. Looking at the instructions, the part required looks a lot like what Chris has posted:
http://www.toyota-tech.eu/aimuploads/%7B...018000.pdf
![[Image: 395572195.jpg]](http://pic100.picturetrail.com/VOL744/3949855/20285147/395572195.jpg)
![[Image: 395572197.jpg]](http://pic100.picturetrail.com/VOL744/3949855/20285147/395572197.jpg)
The M4 size should fit in an 8mm hole by the specs, the 10mm are just too big? at least there pretty easy to get hold of :thumbup1: Should help sell the kits too if they have a proper fitting kit? :thumbup1:
i brought a pack of the m4 long ones, want to try and fit these next week, hopefully they will fit