Anyone got a TTE bumper laying around they can measure?
Anyone got a TTE bumper laying around they can measure?
Dimensions needed: Spacing between holes horizontally and vertically
How much the top and bottom holes are offset (I think they are offset bout about 10-20mm because the mesh is a sort of rhombus shape)
Really the easiest way of doing this would be if someone has one of the mesh panels not fitted to a car to measure, I would measure mine but I don't have ramps or access to a lift so I can't see
sprinter2012
03-06-2019, 01:55 AM #1I'm planning something clever for one of my mods, and I basically need to know what the spacings are on the holes that hold the mesh to the drivers side small mesh panel on a TTE bumper.
Dimensions needed: Spacing between holes horizontally and vertically
How much the top and bottom holes are offset (I think they are offset bout about 10-20mm because the mesh is a sort of rhombus shape)
Really the easiest way of doing this would be if someone has one of the mesh panels not fitted to a car to measure, I would measure mine but I don't have ramps or access to a lift so I can't see
I've got a couple of bits planned for mine hopefully, quite intrigued as to what youre up to
![[Image: OJCSig.jpg]](http://i462.photobucket.com/albums/qq341/dh-all-the-way/OJCSig.jpg)
DanielWatts Banging 9.5J Wheels 'coz that's how you roll
I dont have the mesh fitted in mine, as the guy didnt have it when i bought it, Im pretty low and dont have ramps, but i'll have a crack at it if you like mate
I've got a couple of bits planned for mine hopefully, quite intrigued as to what youre up to
DanielWatts Banging 9.5J Wheels 'coz that's how you roll
1 Guest(s)
1 Guest(s)
Views 317
Last Post by
Views 641
Last Post by
Views 650
Last Post by
Views 5,481
Last Post by
Views 453
Last Post by