Stix's IS200

JapCarForum Cars, Cars, Cars! Project Cars Stix's IS200

Stix's IS200

Pages (45): Previous 1 … 25 26 27 28 29 … 45 Next

mattlaw
Senior Member

572

05-12-2020, 08:53 PM

#261

Pry bar lol

mattlaw

05-12-2020, 08:53 PM #261

Pry bar lol

S
Banned

1,153

06-12-2020, 07:10 AM

#262

mattlaw Pry bar lol

I tried that, where do you put the leverage point? I couldn't find anywhere that I didn't think would break the minute I applied any pressure.

S

06-12-2020, 07:10 AM #262

mattlaw Pry bar lol

I tried that, where do you put the leverage point? I couldn't find anywhere that I didn't think would break the minute I applied any pressure.

Sparkystav
Administrator

14,683

06-12-2020, 07:10 AM

#263

Matts right, think I put mine onto the block over the top of the pump.

Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.

OutlawJapClub Admin Team

Sparkystav

06-12-2020, 07:10 AM #263

Matts right, think I put mine onto the block over the top of the pump.

Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.

OutlawJapClub Admin Team

S
Banned

1,153

06-12-2020, 07:36 AM

#264

Right ill have another go tonight Smile

if I can bring myself to do It! Thanks lads!

also when I went to work this morning someone's had a go at my favourite sticker Sad

Edited 17-01-2013, 11:23 AM by S.

S

06-12-2020, 07:36 AM #264

Right ill have another go tonight Smile if I can bring myself to do It! Thanks lads!

also when I went to work this morning someone's had a go at my favourite sticker Sad

[Image: IMAG0216.jpg]

mattlaw
Senior Member

572

06-12-2020, 08:56 AM

#265

I loosen off the bottom 14mm then just crack off the top 14 mm, and put the pry bar against the front right part of the braket where the bolt goes through, and between the water pump body an just gently give it a nudge

mattlaw

06-12-2020, 08:56 AM #265

S
Banned

1,153

06-12-2020, 09:15 AM

#266

mattlaw I loosen off the bottom 14mm then just crack off the top 14 mm, and put the pry bar against the front right part of the braket where the bolt goes through, and between the water pump body an just gently give it a nudge

Ah spot on Smile

thanks again!

S

06-12-2020, 09:15 AM #266

mattlaw I loosen off the bottom 14mm then just crack off the top 14 mm, and put the pry bar against the front right part of the braket where the bolt goes through, and between the water pump body an just gently give it a nudge

Ah spot on Smile

thanks again!