Turbo manifold 1g fe is200
Turbo manifold 1g fe is200
jay_russell
07-03-2023, 04:45 PM #11It wont fit i think from when i had mine built. Ike did them and this guy on here did them and i have a guy here in sweden that did mine.you will need to do a custom manifold from start to finish
![[Image: LexuS-Copy.jpg]](http://i65.photobucket.com/albums/h204/Sparkystav/LexuS-Copy.jpg)
Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.
Sparkystav
08-03-2023, 07:25 AM #12I'll be honest alexmid, all genuine manifolds made for the IS200 are pretty expensive. So of your only looking at spending £300 your best going the adapted 1jz route.
Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.
Jimbob-T-Lex
08-03-2023, 05:47 PM #13I have a 1gfe t4 manifold mate Ike engineering one £280 plus p+p
There is no point forcing a jz to fit. You will need a stainless flange cut anyway as you can't weld the stainless jz manifold to the fe manifold unless you want it to fall off and port spacing is different it will be a ***** to get it to fit. The one jimbob is selling is a dam good price for what it is. If you want to do it on the super cheap get some sch40 pipe elbows, get a flange, a welder and make a log manifold
1 Guest(s)
1 Guest(s)
Views 496
Last Post by
Views 339
Last Post by
Views 171
Last Post by
Views 391
Last Post by