Yellow IS200

JapCarForum Cars, Cars, Cars! Project Cars Yellow IS200

Yellow IS200

Pages (20): Previous 1 … 16 17 18 19 20 Next

Wayne
Senior Member

607

22-01-2025, 06:16 PM

#181

Throwing up a P0110 fault, so I'm assuming I've stressed the wires on the intake sensor.

Wayne

22-01-2025, 06:16 PM #181

Throwing up a P0110 fault, so I'm assuming I've stressed the wires on the intake sensor.

Wayne
Senior Member

607

03-02-2025, 02:59 PM

#182

Got myself one of them fancy cable operated bypasses. Car keeps jumping into limp mode. Gotta rotate my bypass pipe though.

[Image: 3176vr8.jpg]

Wayne

03-02-2025, 02:59 PM #182

Got myself one of them fancy cable operated bypasses. Car keeps jumping into limp mode. Gotta rotate my bypass pipe though.

[Image: 3176vr8.jpg]

Sparkystav
Administrator

14,683

03-02-2025, 03:31 PM

#183

It keeps going in limp with the new bypass? Any codes?

Could be the throttle too tight

Sent from my iPad using Tapatalk

Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.

OutlawJapClub Admin Team

Sparkystav

03-02-2025, 03:31 PM #183

It keeps going in limp with the new bypass? Any codes?

Could be the throttle too tight

Sent from my iPad using Tapatalk

Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.

OutlawJapClub Admin Team

Wayne
Senior Member

607

03-02-2025, 08:12 PM

#184

Nah car is going into limo mode with the old bypass, ain't had chance to try the cable one, linkage is fouling on my inlet so need to change it... Again

Wayne

03-02-2025, 08:12 PM #184

Nah car is going into limo mode with the old bypass, ain't had chance to try the cable one, linkage is fouling on my inlet so need to change it... Again

Sparkystav
Administrator

14,683

04-02-2025, 04:34 PM

#185

Ah right

Sent from my iPad using Tapatalk

Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.

OutlawJapClub Admin Team

Sparkystav

04-02-2025, 04:34 PM #185

Ah right

Sent from my iPad using Tapatalk

Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.

OutlawJapClub Admin Team

P.Nicolov
Junior Member

06-02-2025, 02:03 PM

#186

Mate, it seems that just extending the short pipe for the bypass will do the trick. Or rotating it. But a bit of welding is inevitable Smile

It's going to be worth it, so don't get frustrated by some metalwork Big Grin

Very nice build btw!

Mate, it seems that just extending the short pipe for the bypass will do the trick. Or rotating it. But a bit of welding is inevitable Smile It's going to be worth it, so don't get frustrated by some metalwork Big Grin

Very nice build btw!

Wayne
Senior Member

607

06-02-2025, 05:57 PM

#187

Aye it'll get there, may have a few more grey hairs before it's running right though Big Grin

Wayne

06-02-2025, 05:57 PM #187

Aye it'll get there, may have a few more grey hairs before it's running right though Big Grin

Wayne
Senior Member

607

17-02-2025, 06:53 PM

#188

Finally got my cabe bypass fitted (I'll get some pics up tomorrow)! The round the block I did for 'testing' seems to have gone good. No limp mode, even when holding it at part throttle down a dual carriageway. I'll find out more tomorrow! But fingers cross I can freely drive now.

Massive thanks to Plamen, not only for the part but for the advice. I've also ordered a 150mm pulley from him, so depending on when I can get my hands on some 1ZZ injectors it may well be done by Japfest!

Wayne

17-02-2025, 06:53 PM #188

Sparkystav
Administrator

14,683

18-02-2025, 04:08 PM

#189

Cant wait to see it mate

Sent from my iPad using Tapatalk

Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.

OutlawJapClub Admin Team

Sparkystav

18-02-2025, 04:08 PM #189

Cant wait to see it mate

Sent from my iPad using Tapatalk

Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.

OutlawJapClub Admin Team

Wayne
Senior Member

607

18-02-2025, 06:24 PM

#190

Sparkystav Cant wait to see it mate

Sent from my iPad using Tapatalk

Still not 100%, but no limp mode or anything of the sort, the linkage is just catching on my silicone bend, so I'm either gonna have to make a plate up to raise the bypass slightly or get a longer pipe welded on. A plate will be my first port of call, reckon it'll leak though. I'l just gasket weld the **** out of it. :whistling:

Injectors have been ordered, anyone know of a reputabe place I can get O-rings from?