SPC Horsham Project IS 550
SPC Horsham Project IS 550
SPChorsham.com spent a little time on the car this week,i fitted the bigger injectors and changed the fuel pressure reg to a std one.'not rising rate'Still with the standard internals ? That'll be interesting :biggrin:
so the car should go on the dnyo monday and come out with the magic 300bhp.
SPChorsham.com spent a little time on the car this week,i fitted the bigger injectors and changed the fuel pressure reg to a std one.'not rising rate'Still with the standard internals ? That'll be interesting :biggrin:
so the car should go on the dnyo monday and come out with the magic 300bhp.
That all sounds very good and hopefully you guys will get the 300 figure .
Would be interesting to get a total cost for doing this to an IS200 , I mean a drive in drive out and a time scale would also be helpful
sounds good lads
Bandit That's good news mate,
how's the engine holding up to the increased power so far? :thumbup1:
Bandit That's good news mate,
how's the engine holding up to the increased power so far? :thumbup1:
Marsdendean That does sound very promising - are these "easy" 6500 miles?
Marsdendean That does sound very promising - are these "easy" 6500 miles?
supratruck well over 85 dyno runs
supratruck well over 85 dyno runs
supratruck Car has been good as gold and done over 6500 miles on this set up already and well over 85 dyno runs and some of those were wait for it 0.7 / 0.8 bar
so its pretty well proven so far :biggrin:
supratruck Car has been good as gold and done over 6500 miles on this set up already and well over 85 dyno runs and some of those were wait for it 0.7 / 0.8 bar
so its pretty well proven so far :biggrin:
Bandit Thats great mate, :thumbup1:
The oil changes i did at every 2-3000 miles must of been a good thing then :laugh:
Thanks for keeping us up to date with it mate, Good to see things are working well on the project :thumbup1:
Bandit Thats great mate, :thumbup1:
The oil changes i did at every 2-3000 miles must of been a good thing then :laugh:
Thanks for keeping us up to date with it mate, Good to see things are working well on the project :thumbup1: