Mazda RX-8 PZ mods to date
Mazda RX-8 PZ mods to date
![[Image: cimg1370m.jpg]](http://img707.imageshack.us/img707/6020/cimg1370m.jpg)
New Rear Roof Spoiler, I had to prime & now in the painting stages
![[Image: cimg1371q.jpg]](http://img707.imageshack.us/img707/5243/cimg1371q.jpg)
Bought another engine cover as a painting project over the summer, not sure what to do with it yet, maybe a rising sun on white !
![[Image: cimg1375t.jpg]](http://img402.imageshack.us/img402/2337/cimg1375t.jpg)
![[Image: cimg1376f.jpg]](http://img63.imageshack.us/img63/3554/cimg1376f.jpg)
And these....
to go with this
![[Image: cimg1377.jpg]](http://img263.imageshack.us/img263/5075/cimg1377.jpg)
![[Image: cimg1378.jpg]](http://img6.imageshack.us/img6/6172/cimg1378.jpg)
Set of oil temp, oil pressure & volt gauges all mounted. Bought off another RX8 owner and they looked like this mounted in his car
![[Image: gaugesz.jpg]](http://img94.imageshack.us/img94/6791/gaugesz.jpg)
So got a bit of work to do. Fitting the gauges will be a major task for me & as for the sandwich plates, well any help from anyone would be appreciated, got instructions etc but hands on advice would be good too.
Also have lowered the number plate below the main grill
![[Image: cimg1366.jpg]](http://img534.imageshack.us/img534/5963/cimg1366.jpg)
I prefer this look
and changed out the white side indicator covers (did this at last JAE) to smoked ones along with adding some eyebrows in piano black.
![[Image: cimg1368en.jpg]](http://img94.imageshack.us/img94/4772/cimg1368en.jpg)
So plenty to keep me busy.....and I have just bought a 2nd hand Mazda Aero body kit, not too OTT really more trim than bodykit, but this has not been delivered yet. That will need a repaint to match my car.
Cheers
Bobby
Shy boys don't get sweeties.
Well I have not really been doing much to the car as there was not anything on the market I fancied until this lot turned up and of course I had to get back modding. So recently purchased:
New Rear Roof Spoiler, I had to prime & now in the painting stages
Bought another engine cover as a painting project over the summer, not sure what to do with it yet, maybe a rising sun on white !
And these....
to go with this
Set of oil temp, oil pressure & volt gauges all mounted. Bought off another RX8 owner and they looked like this mounted in his car
So got a bit of work to do. Fitting the gauges will be a major task for me & as for the sandwich plates, well any help from anyone would be appreciated, got instructions etc but hands on advice would be good too.
Also have lowered the number plate below the main grill
I prefer this look
and changed out the white side indicator covers (did this at last JAE) to smoked ones along with adding some eyebrows in piano black.
So plenty to keep me busy.....and I have just bought a 2nd hand Mazda Aero body kit, not too OTT really more trim than bodykit, but this has not been delivered yet. That will need a repaint to match my car.
Cheers
Bobby
Shy boys don't get sweeties.
Tinted Glass-Sports Grill-Debadged-TTE Spoiler-TTE Lowering Springs-PLUK Kazama Exhaust-18" Aero Alloys-K&N Air Filter-Denso Iridium Power Spark Plugs-Quad Tail Light Conversion-6000K HID-X-White High Beam-6 LED Sidelights-Quad LED Boot Light-JDM OEM Smoked Front Fogs-JDM Blue Reverse Bulbs-LS430 Smoked Side Repeaters-6 LED Side Repeaters-Chrome Indicator Bulbs-Alpine HU-Rear Headrest Monitors-PIAA Super Sporza-Fan Washer Jets-Lex Tax Disc Holder-Chrome Gear Knob-2003 Cup Holder-Toyo Proxes T1-R
Lovely motor mate:thumbup1:
Tinted Glass-Sports Grill-Debadged-TTE Spoiler-TTE Lowering Springs-PLUK Kazama Exhaust-18" Aero Alloys-K&N Air Filter-Denso Iridium Power Spark Plugs-Quad Tail Light Conversion-6000K HID-X-White High Beam-6 LED Sidelights-Quad LED Boot Light-JDM OEM Smoked Front Fogs-JDM Blue Reverse Bulbs-LS430 Smoked Side Repeaters-6 LED Side Repeaters-Chrome Indicator Bulbs-Alpine HU-Rear Headrest Monitors-PIAA Super Sporza-Fan Washer Jets-Lex Tax Disc Holder-Chrome Gear Knob-2003 Cup Holder-Toyo Proxes T1-R
Rabster looking good mate should be fun to fit for you if you dont do it before jae im sure we could all muck in then ...
I will give it a go mate it is the sandwich plates that worry me, cheers though I might take you up on it at JAE.
Cheers
Bobby
Shy boys don't get sweeties.
Rabster looking good mate should be fun to fit for you if you dont do it before jae im sure we could all muck in then ...
I will give it a go mate it is the sandwich plates that worry me, cheers though I might take you up on it at JAE.
Cheers
Bobby
Shy boys don't get sweeties.
Here is an other option of gauge pod for your RX8
http://cgi.ebay.com/ebaymotors/Mazda-RX-...ccessories
LEXUS IS200 - The most fun car to go sideways
Nice mods mate. will you ever stop modding??? :lol:
Here is an other option of gauge pod for your RX8
http://cgi.ebay.com/ebaymotors/Mazda-RX-...ccessories
LEXUS IS200 - The most fun car to go sideways
Bobby Touche Dimis :laugh:
Seen them but they are for USA cars & you guys that drive on the wrong side of the road so they face in the wrong direction (towards the passenger) for us civilised drivers.
:biggrin:
hock: yes you are correct. I forgot about this small difference moke:
LEXUS IS200 - The most fun car to go sideways
Bobby Touche Dimis :laugh:
Seen them but they are for USA cars & you guys that drive on the wrong side of the road so they face in the wrong direction (towards the passenger) for us civilised drivers.
:biggrin:
hock: yes you are correct. I forgot about this small difference moke:
LEXUS IS200 - The most fun car to go sideways
We'll have to meet up again soon bud :thumbup:
Lexus IS200 Mods--TTE Supercharger, Tein Superstreet Coilovers & EDFC, 6000K HID Lights, HKS Silent High Power Exhaust, DBA Front Discs, Kenwood DNX9240 Head Unit, 19" Rims, TRD Kit, FIGS Bonnet Struts, Greddy Pillar Pod & Defi Gauges, TTE Red ARBS . And Been To WIM twice
Looking good Bobby, bet you cant wait to get the gauges fitted .
We'll have to meet up again soon bud :thumbup:
Lexus IS200 Mods--TTE Supercharger, Tein Superstreet Coilovers & EDFC, 6000K HID Lights, HKS Silent High Power Exhaust, DBA Front Discs, Kenwood DNX9240 Head Unit, 19" Rims, TRD Kit, FIGS Bonnet Struts, Greddy Pillar Pod & Defi Gauges, TTE Red ARBS . And Been To WIM twice
1 Guest(s)
1 Guest(s)
Views 2,826
Last Post by
Views 1,941
Last Post by
Views 3,793
Last Post by
Views 1,723
Last Post by