Abs kicking in when brackin at 10mph

JapCarForum Car Manufacturers Lexus/Toyota IS200 / IS300 / SPORTCROSS / Altezza Abs kicking in when brackin at 10mph

Pages (5): Previous 1 2 3 4 5

Lexusboy
Posting Freak

9,267

11-04-2018, 08:43 AM

#41

Glad you got there in the end John:thumbup1:

Lexusboy

11-04-2018, 08:43 AM #41

Glad you got there in the end John:thumbup1:

John G
Senior Member

418

11-04-2018, 08:44 AM

#42

Outlaws came to the rescue again, just chargin camera then ill make a thread later

John G

11-04-2018, 08:44 AM #42

Outlaws came to the rescue again, just chargin camera then ill make a thread later

widnes_is200
Member

232

11-04-2018, 08:50 AM

#43

glad its sorted! car looks real smart at that hight now john:thumbup1:

[SIGPIC][/SIGPIC]

widnes_is200

11-04-2018, 08:50 AM #43

glad its sorted! car looks real smart at that hight now john:thumbup1:

[SIGPIC][/SIGPIC]

John G
Senior Member

418

11-04-2018, 12:52 PM

#44

Here was what i was faced with when i removed my drivers wheel and my dads drivers wheel to compare

My dads!
[Image: car075.jpg]

Mine

So i removed the sensor and filled the sensor hole with a glove
[Image: car078.jpg]

1 piece of emery cloth
[Image: car080.jpg]

I then set about cleaning the area around the sensor where the bolt clamps in, this is afterwards
[Image: car081.jpg]

No more pictures after this stage but basically i refitted it and did the same turned out it was just a really tight fit, i slight tap with a mallet! (being carefull not to go to hard) it sat flush, problem solved

John G

11-04-2018, 12:52 PM #44

Here was what i was faced with when i removed my drivers wheel and my dads drivers wheel to compare

My dads!
[Image: car075.jpg]

Mine
[Image: car076.jpg]

So i removed the sensor and filled the sensor hole with a glove
[Image: car078.jpg]

1 piece of emery cloth
[Image: car080.jpg]

I then set about cleaning the area around the sensor where the bolt clamps in, this is afterwards
[Image: car081.jpg]

No more pictures after this stage but basically i refitted it and did the same turned out it was just a really tight fit, i slight tap with a mallet! (being carefull not to go to hard) it sat flush, problem solved